Ceramic Filter for Various Systems

This ceramic filter is the first filtration step and is placed in the upper tank of the water filter system. It is suitable for various sizes and models of Doonam, EVA, Keosan, Young Do, Aqualine and Coolmart CM101 water filters (glass and plastic).

It is made of diatomaceous earth, compressed under high pressure and fired, and forms a high-density micro-ceramic filter with a filtration fineness of 0.2 µm (0.0002 mm).

Service life
The ceramic filter lasts between 6 months and 10 years. This depends mainly on the quality and composition of the water. It is best to replace it when the water flow decreases.

Advice:
To extend the life of this filter, you can clean it (once or twice at most) with clean water and a new double-sided sponge, using the rough side. Do not press too hard, because the thickness of the filter wall (1 cm) is essential for your water filter to work well. So handle it with care, especially if you filter non-drinkable water from a spring or water tank.

Installing the ceramic filter:

Place the ceramic filter in the bottom of the upper tank and make sure you fit the seal on the outside of the tank before fitting the wing nut. Tighten the nut without forcing it.

MAINTENANCE:

• If you filter water from a well, spring or tank, rinse the outside of the filter regularly so that it does not clog with sediment.
• If you use this filter for hard mains water, rub the ceramic clean now and then with water and the roughest side of a dish sponge.
• Never use detergent or acid. Above all, do not use vinegar, which could destroy or change the pore size of this fine ceramic.
• Suitable for all gravity fountains with an identical dome (Doonam, Coolmart, EVA, Aqualine, Young Do, Keosan, etc.), so NOT for Doonam models 201 and Neos, nor for some Nikken water filters.